Notes from the Road (4) - Glulam Beams and Roof Trusses

You've all been there.

You're sitting in church, and the preacher has just made a rousing appeal to your higher senses. Your heart quickens, you get a lump in your throat, you raise your eyes toward the heavens, and you find yourself wondering...

How did they make those great wooden beams up there?

Well, now you know.

The folks sharing this mystery of the universe are the good folks of Rigid-Ply Rafters, a Pennsylvania company based in Richland, just east of Harrisburg. It's really a rather simple process. The lumber components are glued on the face, then stacked into the appropriate design in the large clamping device seen in the video. Then the clamps are tightened on each side; the beam is held until the glue is cured; and then the beam is removed and trimmed to final dimensions.

Rigid-Ply also makes prefabricated roof trusses, and I shot this quick video mainly to time the process.

Two-and-a-half minutes. That's pretty darn quick, especially when you compare it to the time framers spend building the same thing on-site. And the steel plate fasteners provide a much stronger connector than nails driven in at angles by framers hanging in the air by one arm. So, the modern prefabricated wooden building component is generally a higher quality product produced more efficiently than the stick-built buildings of days past.

Unfortunately, that good story is not the end of the story. Efficiency is a never-ending process, and at some point, human workers just aren't cost-effective enough.

Looks like the best skill for the future is to be a robot technician.

Tip Amount


Keith Atherholt said…
If you stand in the lobby of the Forest Resource Building and look up you will see glue-lam beams made from red maple by Rigid Ply. They were part of the donation by the Pennsylvania Forest Products Association. The lumber was donated by several saw mills and dried at Dwight Lewis Lumber Co. We ripped and planed the lumber at Lewis Lumber Products and that required PSU to "certify" it by ASTM Standards (as none are technically published for red maple, but Jon Janowiak oversaw that process and got them accepted)!

Wood Products Department to the rescue!

People are reading....

Going Wood with Hannah Barron

Great Designs in Wood (74) - The Olde Oaken Barrel

Real Firewood Stacking

A Hidden World of Beauty - Japanese Keyaki

Who Says Go Wood is Boring?

The Tangled Web of Palm Oil Production - We've Been Here Before

Martha King Goes Wood Her Way

Global Warming Needed in Pennsylvania

Survival of the Fittest: 2019 is a Whole New Ball Game

Best of Logging 2018